

ENESEAL MP was initially applied in October, 2008.
WATER-BASED PENETRANT / WEATHER BARRIER FOR MASONRY, CONCRETE, BRICK & STONE
UV resistant, breathable penetrant provides unrivaled water repellent properties to most mineral substrates. Environmentally safe. Invisible when dry.


These photos were taken after a heavy rainstorm on Long Island in October, 2014 – 6 years after the initial application.
ENESEAL MP forms a hydrophobic barrier inside masonry pores that repels water and water-borne salts. This significantly reduces the damaging effects of moisture penetration into concrete and masonry, such as surface scaling, freeze-thaw cracking and corrosion of reinforcing steel.
ENESEAL MP is a single component, water-based, ultra-low viscosity weather barrier which dries to a completely invisible, water repellent masonry sealer. It provides extraordinary weather protection to virtually all types of concrete, masonry and mineral surfaces.
The invisible barrier forms below masonry surfaces to depths of up to 3/4 inch and, therefore, will not wear away as a result of surface traffic and/or harsh weather conditions. This barrier is also breathable – allowing water vapor to escape from inside the concrete or masonry while dramatically reducing liquid water penetration into the substrate.
Colors
Note: Other colors are available on a “special order” basis. However, there are minimum / multiple quantity requirements for such orders and there may be an increase in cost. Additionally, due to formulation restrictions, not all colors are possible for all materials. Speak to your local ENECON Sales Representative for more information.
Due to monitor / printer differences, actual colors may vary slightly from the representations appearing in this chart.